VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
- 7. Transmission
7.1.2. A coupling disk
7.2. A mechanical transmission
- 7.3. Automatic transmissions
7.3.1.2. Adjustment of the mechanism of a gear change
7.3.2. Completely an automatic transmission
7.3.2.1. Adjustment of a cable of switching (an automatic transmission)
7.3.2.2. All-wheel drive cars
8. A running gear
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
13. An electric equipment
|
Cable of management of an automatic transmission
1 – spherical fastening of a cable,
2 – the lever of a choice of transfers, |
3 – a bolt, 25 Nanometers,
4 – a nut of fastening of a cable, 10 Nanometers |
Check
| PERFORMANCE ORDER |
| 1. Lift the car and fix it on supports or establish it over a viewing hole. |
| 2. Establish the selector lever in position Р, fig. the Cable of management of an automatic transmission see. |
| 3. On a transmission, having pulled upwards, remove a spherical tip of a cable of management of a transmission from the lever of a choice of transfers. |
| 4. Move the lever of the selector from position Р to position 1. Thus the selector lever should move easily and smoothly. Otherwise replace a cable of management with a transmission. |
| 5. Move the selector lever to R.Pri's position it the lever of a choice of transfers on a transmission should be in the lowermost position. Check up combination of a spherical tip of a cable of management by a transmission with the lever of a choice of transfers on a transmission. If combination is absent, it is necessary to adjust a cable of management of a transmission. |
|
Adjustment
| PERFORMANCE ORDER |
| 1. Move the selector lever to River position |
| 2. Move the lever of a choice of transfers on a transmission to the lowermost position. Thus the parking ratchet should be latched. |
| 3. Ослабьте a bolt of fastening of a support of a cable of management of a transmission. Moving a support, establish it in such position when the cable tip will be combined with the lever of a choice of transfers on a transmission. In this position tighten a bolt (3), крепящий support of a transmission the moment of 25 Nanometers, fig. the Cable of management of an automatic transmission) see. |
| 4. Spend a control trip and check up work of the lever of the selector. Engine start is possible only in positions Р and N the selector lever. |
| 5. Include ignition. On the car which is at a stop, the selector lever can be moved only from positions Р and N by simultaneous pressing of a pedal of an accelerator. |
|
|
|
