VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
- 8. A running gear
8.1.2. An amortisation rack
- 8.2. A back suspension bracket
8.2.2. Unscrewing of the top fastening of the shock-absorber
8.2.3. Removal and shock-absorber and spring installation
8.2.4. Removal and installation of bearings/naves of back wheels
8.2.5. An amortisation rack of all-wheel drive cars
8.2.6. Shock-absorber check
8.2.7. Shock-absorber recycling
8.3. Wheels and tyres
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
13. An electric equipment
|
Elements of fastening of the bearing/nave of a back wheel on front-wheel cars
1 – самоконтрящийся a bolt, 35 Nanometers,
2 – a support of a back brake,
3 – bolts, 60 Nanometers,
4 – a brake disk,
5 – bolts, 60 Nanometers, |
6 – the bearing/nave of a back wheel,
7 – тампованный a casing,
8 – a back beam,
9 – the gauge of rotation of a back wheel,
10 – a clamp of the gauge of rotation of a back wheel |
The prevention At installation of a bolt 1 it is necessary to use a new bolt.
The bearing/nave of a back wheel 6 represent uniform knot. Adjustment of the bearing of a back wheel in this case is not required.
Removal
| PERFORMANCE ORDER |
|
1. Unscrew two bolts of fastening of a brake support, thus, using a thin wrench, keep directing finger from проворачивания. |
| 2. Remove brake колодки. |
| 3. Remove a brake disk. |
|
4. Through an aperture in a nave, unscrew five bolts of fastening of the bearing/nave of a back wheel. |
| 5. Remove the bearing/nave of a back wheel. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish the bearing/nave of a back wheel and screw bolts, having tightened their moment of 60 Nanometers. |
| 2. Establish a brake disk. |
| 3. Establish brake колодки. |
| 4. Establish a support of a brake and fix its new самоконтрящимися bolts, thus a thin wrench keep directing finger from проворачивания. |
|
|
|
