VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
- 8. A running gear
8.1.2. An amortisation rack
- 8.2. A back suspension bracket
8.2.2. Unscrewing of the top fastening of the shock-absorber
8.2.3. Removal and shock-absorber and spring installation
8.2.4. Removal and installation of bearings/naves of back wheels
8.2.5. An amortisation rack of all-wheel drive cars
8.2.6. Shock-absorber check
8.2.7. Shock-absorber recycling
8.3. Wheels and tyres
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
13. An electric equipment
|
The information stated in given subsection, concerns front-wheel cars.
Arrangement of bolts of the top fastening of the back shock-absorber
Elements of the bottom fastening of the back shock-absorber
|
|
1 – a nut,
2 – a bolt,
3 – the shock-absorber |
Removal
| PERFORMANCE ORDER |
| 1. On the car standing on wheels from under the car unscrew bolts of the top fastening of the shock-absorber to a car body (fig. the Arrangement of bolts of the top fastening of the back shock-absorber see). For access improvement to bolts of fastening of the shock-absorber it is possible to raise the car slightly. |
| 2. For unloading of a spring of a back suspension bracket, lift a back part of the car so that the wheel has been raised over the earth on 10 see Remove a back spring from support and take it from under the car. If necessary the assistant should turn a beam of a back suspension bracket downwards. |
| 3. Unscrew a nut and take a bolt of the bottom fastening of the shock-absorber. Having moved upwards, take the bottom part of the back shock-absorber from a back beam, lower the shock-absorber and take it from under the car, fig. Elements of the bottom fastening of the back shock-absorber see. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish the shock-absorber into place, insert a bolt of fastening of the shock-absorber and screw on it a nut, without tightening it it is definitive. |
| 2. Establish a spring so that extreme coils of a spring settled down on support thus, as is shown in fig. the Correct arrangement of the bottom coil of a spring in a spring nest. |
| 3. Screw the top fastening of the shock-absorber on a car body. |
| 4. Lower the car on the earth so that back wheels were on the earth, but access to bolts of the top fastening of the back shock-absorber was thus possible. |
| 5. Tighten bolts of the top fastening of the back shock-absorber the moment of 45 Nanometers. Tighten a bolt and a nut of the bottom fastening of the back shock-absorber the moment of 50 Nanometers and then tighten on a corner 90 . |
|
|
|
