Auto Manual of VW Passat B5


VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
- 8. A running gear
   - 8.1.2. An amortisation rack
      8.1.2.1. Repair of an amortisation rack
      8.1.3. Removal and power shaft installation
      8.1.4. Quantity of greasing G 000 603 for external hinges of power shafts
      8.1.5. Greasing of the internal three-humeral hinge
      8.1.6. Filling of the SHRUS with greasing G6
      8.1.7. Replacement of the internal hinge of equal angular speeds
      8.1.8. Replacement of the external hinge of equal angular speeds
      8.1.9. Dismantling of the external hinge of equal angular speeds
      8.1.10. Malfunctions of power shafts
    8.2. A back suspension bracket
    8.3. Wheels and tyres
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
13. An electric equipment



49e3918c
свет в доме,

8.1.9. Dismantling of the external hinge of equal angular speeds
THE GENERAL DATA

As spare parts to the hinge protective covers, washers, lubricant, a nut of a power shaft and spring lock rings are delivered.

PERFORMANCE ORDER
1. Чертилкой note positions of a nave and the hinge case.
2. Turn a hinge nave in the case and take each sphere. Stack spheres as removal, for the subsequent repeated installation in initial positions.
3. Turn a hinge separator so that two rectangular cracks were combined with the case, then take a separator and a nave.
4. Turn a nave in a separator so that one of nave parts has entered into one of rectangular cracks in a separator, turn a nave and take it from a separator.
5. Clear all details of the hinge and check up their condition. If there are wear tracks or corrosion, replace the hinge.
6. Put 45 gramme in the hinge case, then establish a separator with a nave in the hinge case. Consistently insert spheres into a nave, and check up that a nave in a separator and the case were established in a starting position (on earlier made labels). Establish a new lock ring in a nave, then press into the hinge the remained half of greasing (45 gramme).