Auto Manual of VW Passat B5



VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
- 8. A running gear
    8.1.2. An amortisation rack
    8.2. A back suspension bracket
   - 8.3. Wheels and tyres
      8.3.2. Instructions on operation of tyres
      8.3.3. Gate check
      8.3.4. Shift of wheels
      8.3.5. Disks and tyres
      8.3.6. A spare wheel
      8.3.7. Replacement of wheels
      8.3.8. Bolts-sekretki for fastening of wheels
      8.3.9. Chains противоскольжения
      8.3.10. A car raising
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
13. An electric equipment



49e3918c
доме

8.3.10. A car raising
THE GENERAL DATA

Basic places under a jack on cars the Sedan and the Versatile person


Installation of a jack for a car raising


The prevention

If it is necessary to make works under the car, for the insurance it is necessary to use supports. Car support only one jack is insufficient.

Do not start the engine of the lifted car it it is dangerous.


For a car raising it is necessary to use a jack established under basic places of a body of the car which are located approximately in 17 sm from a corresponding wheel arch, Basic places under a jack fig. see cars the Sedan and the Versatile person and fig. Installation of a jack for a car raising.
The prevention

If the jack is established not under a basic place of a body, probably, damage of a body of the car. Besides, there is a danger of reception of a trauma.


Establish a jack under the car.

The jack paw should cover densely a vertical edge of a longeron that at lifting of the car the jack could not slide off.

Simultaneously it is necessary to level position of a jack and to lift a jack paw until she densely will not lie down to a vertical edge.


The prevention

At jack installation on a soft ground, probably, falling of the car from a jack. Therefore it is necessary to put a jack on a firm ground. If it is necessary, it is necessary to use steady and rather big support on the area.


For car posting it is necessary to use the lift.

To avoid damages of a bottom of the car, it is necessary to use necessarily corresponding linings from прорезиненного a material.


The prevention

The car in no event cannot be lifted under the oil pallet картера, under a transmission, under back or forward axes, differently there can be serious damages of knots and units.


Before entrance on the lift it is necessary to be convinced that there is a sufficient distance between low-sited points of the car and lift elements.

Installation site of a paw of the lift in a forward part of the car

In a forward part of the car a lift paw establish under the amplifier of the bottom of a body.

Installation site of a paw of the lift in a back part of the car

In a back part of the car a lift paw establish under vertical strengthenings of longerons, in the field of a mark for installation of a jack (1).

The car cannot be lifted in front under vertical intensifying edges of longerons.