The prevention Disks from easy alloys are protected from corrosion by a transparent varnish. Be careful not to damage a varnish covering. At covering damage, cover a disk with a varnish coat.
The zinced wheel bolts can be applied only on steel stamped disks.
Disks from easy alloys fasten only the chromeplated wheel bolts on which there is a conic rotating washer. This washer established under a head of a bolt, protects a disk surface at a tightening of bolts.
Before ввинчиванием, do not grease a carving of bolts of fastening of a wheel.
Standard bolts of fastening of wheels have the sizes – М14х1,5х27,5. The size of a head on a turn-key basis 17 mm.
Tightening of bolts of fastening of a wheel make in regular intervals in some stages in diagonal sequence.
The moment of a tightening of bolts of fastening of a wheel of 120 Nanometers.
PERFORMANCE ORDER |
|
1. Remove a decorative cap of a wheel. For this purpose use mount and wire скобу from a tooling. Wire скоба it is established on an aperture of a cap or on an edge. Pass mount through скобу and, having pulled mount from a wheel, remove a cap. |
2. On the car standing on the earth, tighten a manual brake and ослабьте bolts of fastening of a wheel. |
3. Lift the corresponding party of the car and fix on supports. |
|
4. Unscrew the top bolt of fastening of a wheel. |
|
5. On its place screw in an adjusting pin. Use of an adjusting pin facilitates installation of a spare wheel. |
6. For an exception "прикипания" disks of wheels to a nave, before wheel installation, apply a thin film greasings on the fillet of a nave aligning a disk of a wheel. |
|
|