Auto Manual of VW Passat B5



VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
8. A running gear
9. A steering
- 10. Brake system
   10.2. The general information
   10.3. Systems ABS/EBV/EDS/ASR/ESP
   10.4. Check of the vacuum amplifier of brakes
    10.5. Replacement of lobbies brake колодок
   10.6. Replacement back brake колодок
   10.7. Check of a brake disk
   10.8. A brake disk
   10.9. Prorolling of hydraulic brake system
    10.10. Brake pipelines and hoses
   10.11. The stoplight switch
   10.12. The lever of a manual brake
   10.13. Adjustment of a manual brake
   - 10.14. A cable of a manual brake
      10.14.2. All-wheel drive cars
   10.15. The basic malfunctions of brakes
11. A body
12. Heating, ventilation
13. An electric equipment



49e3918c На сайте www.brazzers-tv.vip смотреть бразерс.

10.14. A cable of a manual brake

10.14.1. Front-wheel cars
THE GENERAL DATA

Arrangement of a thermofilter of an exhaust system

1 – forward section of a thermofilter,
2 – the main section of a thermofilter.

Arrows show an arrangement of nuts of fastening of the main section of a thermofilter.


Adjusting муфта a cable of a manual brake

And – a rotation direction регулировоч ache муфты,
In – a direction of moving of covers of a cable of a manual brake,
With – adjusting муфта,
D – a clamp,
Е – a flange adjusting муфты

Removal

PERFORMANCE ORDER
1. Ослабьте bolts of fastening of back wheels, then lift a back part of the car and fix on supports. Remove back wheels.
2. Remove forward section of a thermofilter.
3. Unscrew nuts and move forward the main section of a thermofilter, fig. the Arrangement of a thermofilter of an exhaust system see.
4. Ослабьте a tension of cables of a manual brake.
5. Remove a clamp (D), fig. Adjusting муфта a cable of a manual brake see.
6. A key on 13 mm keep a flange of a regulator from проворачивания and unscrew adjusting муфту against the stop.
7. Move apart covers of cables of a manual brake.
8. Take скобу, крепящую a cover of a cable of a manual brake to a support of a back brake.
9. Disconnect a cable of a manual brake from the lever of a manual brake on a support. Thus be careful not to damage a protective cover of a manual brake.
10. Release a cable of a manual brake from clamps on a beam of a back suspension bracket.
11. Take from скоб fastenings a wire of the gauge of turns of a wheel.
12. Unscrew nuts, крепящие a thermofilter to sound insulation and move a thermofilter aside.
13. Using a screw-driver edge, remove fixing скобы and release a cable of a manual brake.
14. Using a screw-driver, remove from the console of a cable of a manual brake.
15. Remove decorative furnish of a back part of the central console.
16. A screw-driver through an aperture in the basis of the lever of a manual brake press downwards a cable of a manual brake and disconnect it from the lever of a manual brake.
17. Take a cable of a manual brake.

Installation

PERFORMANCE ORDER
1. Before installation of cables of a manual brake replace plastic details on the jack of cables of a manual brake.
2. Using a screw-driver edge, through an aperture in the basis of the lever of a manual brake, fix from проворачивания the jack of cables of a manual brake.
3. Through the console fix a spherical head in the jack of cables of a manual brake.
4. Fix a cable of a manual brake on the console.
5. Fix a cable of a manual brake on supports of a back brake and fix them скобами.
6. Fix a cable of a manual brake on a back beam.
7. Establish decorative furnish of a back part of the central console.
8. Establish into place and screw a thermofilter on thermoisolation.
9. Fix скобами a wire of the gauge of rotation of a wheel.
10. Screw a thermofilter.
11. Establish back wheels, then lower the car on the earth. Tighten bolts of fastening of wheels in diagonal sequence the moment of 120 Nanometers.