1. Tighten a manual brake, then lift a forward part of the car and fix on supports. Remove a corresponding forward wheel. |
|
2. Establish on a bolt of fastening of a wheel a washer in the thickness of 10 mm and screw in a fastening bolt in an aperture of a brake disk. |
3. Slowly turn a brake disk so that it could be considered from two parties. Deterioration of a brake disk from колодок should be in admissible limits. If there are cracks on a disk, the disk is subject to replacement. |
4. The indicator of hour type check up palpation of a brake disk. The indicator of hour type fix in any convenient place and, turning a brake disk, define its palpation on distance of 10 mm from external edge. |
5. Before check of palpation of a brake disk be convinced that the nave bearing is in a good condition. |
6. Check up a brake disk on presence of cracks, especially round apertures under bolts of fastening of a wheel, and also on presence of deterioration or mechanical damages and, if necessary, replace it. |
|
7. Measure a thickness of a brake disk.
Because on perimetre of a brake disk there is a step, therefore at measurement of a thickness of a brake disk with calliper use enclose under sponges of a calliper two coins. For definition of a true thickness of a brake disk subtract from indications of a calliper a thickness of two coins. |
The prevention Most conveniently also it is precisely possible to measure a thickness of a brake disk with micrometer use. It is necessary to measure a thickness of a brake disk in several points on a circle of a brake disk. For a true thickness of a brake disk it is necessary to accept least of the measured values, fig. the Place of measurement (arrow) of a thickness of a brake disk) see.
|
8. In the presence of scratches or cracks more a brake disk it is necessary to replace than 0,5 mm with depth. |