VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
8. A running gear
9. A steering
- 10. Brake system
10.2. The general information
10.3. Systems ABS/EBV/EDS/ASR/ESP
10.4. Check of the vacuum amplifier of brakes
10.5. Replacement of lobbies brake колодок
10.6. Replacement back brake колодок
10.7. Check of a brake disk
10.8. A brake disk
10.9. Prorolling of hydraulic brake system
- 10.10. Brake pipelines and hoses
10.10.1. Replacement of a brake hose
10.11. The stoplight switch
10.12. The lever of a manual brake
10.13. Adjustment of a manual brake
10.14. A cable of a manual brake
10.15. The basic malfunctions of brakes
11. A body
12. Heating, ventilation
13. An electric equipment
|
The prevention Brake hoses should not contact to oil or fuel. Also it is impossible to varnish brake hoses or other protective structures.
Removal
| PERFORMANCE ORDER |
| 1. Ослабьте bolts of fastening of a forward wheel. Tighten a manual brake, then lift a forward part of the car and fix on supports. Remove a wheel. |
| 2. For reduction of losses of a brake liquid, uncover with пополнительно го a tank of brake system, close a mouth of a tank polyethylene and again screw a cover. It is necessary that the cover tightly closed пополнительный a tank. |
| 3. Unscrew bolts and remove a brake support. |
| 4. Release a brake hose from directing and an arm. |
| 5. Clear area round connecting муфт a brake hose and unscrew a brake hose. Close apertures in a support and a brake highway suitable stoppers. |
|
Installation
The prevention At installation use the brake hoses recommended by the manufacturer.
| PERFORMANCE ORDER |
| 1. Establish a new brake hose, without overwinding it and tighten connecting муфты a brake hose the moment of 15 Nanometers. |
| 2. Turning a steering wheel from an emphasis against the stop, check up that the brake hose moves freely and does not contact to elements of a forward suspension bracket and a body. |
| 3. Establish a support. |
| 4. Remove polyethylene from a jellied mouth пополнительного a tank and pump over a corresponding brake contour. |
| 5. Establish a wheel and lower the car on the earth. Tighten fastening bolts in diagonal sequence the moment of 120 Nanometers. |
|
|
|
