1. Switch off ignition and remove a wire of weight from the accumulator. |
|
2. Open a cover (1) and take an ashtray (2) of a back part of the central console. |
3. Establish the central armrest in vertical position. |
|
4. Take opened rubber заглушку (1) of the central console, unscrew a nut (2). |
|
5. Put forward from the central console a support (1) for glasses. Unscrew two nuts (2), крепящие a back part of the central console. On cars without the central armrest there is only one nut located under an ashtray. |
6. Tighten upwards against the stop the lever of a manual brake. |
|
7. Having pulled along the lever of a manual brake, remove a decorative overlay (1) levers of a manual brake. |
|
8. From two sides of the central console remove заглушки (1), closing bolts and unscrew bolts (2) fastenings of the central console. |
9. On the lever of a manual brake remove a back part of the central console, fig. Removal of a back part of the central console see. |
10. Release a diagnostic socket (2), fig. Removal of a back part of the central console see. |
11. Disconnect an electric socket from the switch of remote opening of a cover топливозаливной mouths (3), fig. Removal of a back part of the central console see. |
|
12. Separate the bottom part of a protective cover (2) from the central console and, having pulled for the handle (1) upwards, remove from the lever of a gear change the handle together with a protective cover. |
13. Raising a back part of forward section of the central console, separate it from the panel of devices and remove from the gear change lever, fig. Removal of forward section of the central console see. |
14. Disconnect an electric socket from прикуривателя (2), fig. Removal of forward section of the central console see. |