Auto Manual of VW Passat B5



VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
8. A running gear
9. A steering
10. Brake system
- 11. A body
   11.2. Care of a body
   11.3. Care of an upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of strong damages of a body
    11.6. The forward cross-section panel
   11.7. A forward bumper
   11.8. Removal of the lever of blocking of a cowl
   11.9. Adjustment of a lateral directing arm of a bumper
   11.10. A back bumper
   11.11. A forward wing
   11.12. Facing of a niche of a forward wheel
   11.13. An air inlet lattice
   - 11.14. A cowl
      11.14.1. Adjustment of position of a cowl
   11.15. A radiator lattice
    11.16. A cable of opening of the lock of a cowl
   11.17. The cowl lock
   11.18. Internal furnish of a door
   11.19. Differences at removal of an upholstery of the right forward door
   11.20. The block of management of door mechanisms
   11.21. Door consolidation
   11.22. Lateral furnish of a luggage space of models the Sedan
   11.23. Lateral furnish of a luggage space of models the Versatile person
   11.24. Back furnish of a luggage space on models the Sedan
   11.25. An upholstery of a cover of a luggage carrier
   11.26. An upholstery of a door of a luggage carrier
   11.27. A covering of a floor of a luggage space on models the Versatile person
   11.28. A luggage carrier cover
    11.29. The luggage carrier lock
   11.30. Adjustment of position of a cover of a luggage carrier / a back door
    11.31. The lock of a back door on models the Versatile person
   11.32. A forward door
   11.33. The cylinder of the lock of a forward door
   11.34. The external handle of opening of a door
   11.35. The door lock
   11.36. Manual lowering of glass of a door
   11.37. Door glass
   11.38. A door arm
   11.39. An internal rear-view mirror
   11.40. The central console
   11.41. A forward ashtray
   11.42. A back ashtray
   11.43. A decorative overlay of the lever (an automatic transmission)
   11.44. Decorative overlays under a radio receiver
   11.45. The bottom furnish of the panel of devices from outside the driver
   11.46. A ware box
   11.47. An internal decorative overlay of an external rear-view mirror
   11.48. The ceiling handle
   11.49. Protivosolnechnye peaks
   11.50. Overlays of thresholds
   11.51. Wind and back has flown down
   11.52. Sitting lobbies
   11.53. A headrest
   11.54. Lateral pillows of safety
   11.55. Back sitting
   11.56. The left back of back sitting
   11.57. A carpet covering
   11.58. Elements of furnish of an interior
   11.59. An external mirror of a back kind/glass of a mirror
   11.60. The case of an external mirror
   11.61. The Protection/bordjurnaja a roof lath
   11.62. A lateral overlay of a body
   11.63. Replacement of rubber tapes of brushes of screen wipers
   11.64. Nozzles of washers of a windscreen
   11.65. Screen wiper levers
12. Heating, ventilation
13. An electric equipment



49e3918c Срочно купить лодку моторную

11.14. A cowl
THE GENERAL DATA

Elements of fastening of a cowl

1 – a cowl,
2 – a rack,
3 – a hose,
4 – a clip,
5 – nozzles of a washer,
6 – a casing of the hinge,
7 – the screw, 6 Nanometers,
8 – the hinge,
9 – a bolt, 25 Nanometers,
10 – a rubber emphasis of a cowl. Changing height of an emphasis by its rotation, the height of installation of a forward part of a cowl changes,
11 – the rubber buffer,
12 – directing a cowl

Arrangement and fastening of a pneumatic support of a cowl

And – spring скоба the top fastening of a support,
In – spring скоба the bottom fastening of a support,

2 – a pneumatic support


Site of support Х for which it is necessary to clamp a support in a vice

Х=50 Mm

Removal

PERFORMANCE ORDER
1. Open a cowl and enclose pure rags under cowl corners to protect a paint and varnish covering of the car at cowl removal.
2. Disconnect a hose from a nozzle of a washer and electric sockets. Adhere to a hose and an electric socket a thin long cord. Extend from a cowl electroconducting and a hose, and untie from them a cord, leaving it in a cowl. Further the cord is required for a tightening in an electroconducting and hose cowl.
3. Using a marker, note position of hinges on a cowl.
4. Ask the assistant to support a cowl in open position and disconnect from a cowl a pneumatic support of a cowl. For this purpose a screw-driver edge raise spring скобу and remove the top part of a support from the spherical hinge on a cowl. If it is necessary to remove a pneumatic support of a cowl from the car, similarly remove the bottom part of a support, fig. the Arrangement and fastening of a pneumatic support of a cowl see.
5. At removal of a pneumatic support of a cowl do not take completely spring скобу from the spherical hinge, otherwise spring скоба it will be deformed, and it is necessary to make replacement of a pneumatic support.
6. If the new pneumatic support for recycling of an old support it is necessary to remove gas from it is established. For this purpose fix support in a vice for site Х shown on fig. the Site of support Х for which it is necessary to clamp a support in a vice. In order to avoid accident necessarily clamp a support for the specified site. On the distance equal of 1/3 lengths, saw the case of a pneumatic support. At a cutting of a support for protection of eyes use points.
7. Unscrew screws, крепящие a casing of the hinge of a cowl and remove a casing.
8. Unscrew bolts of fastening of the left and right hinges of a cowl and, being careful, remove a cowl.
9. Check up a condition of hinges of a cowl on presence люфта and deterioration and, if necessary, replace them.

Installation

PERFORMANCE ORDER
1. Using two assistants, establish a cowl and screw in bolts of fastening of hinges of a cowl by hand. Level cowl hinges according to earlier made labels and tighten bolts of fastening of a cowl.
2. Fix a pneumatic emphasis on a cowl for what with force press an emphasis before its fixing on the spherical hinge of a cowl.
3. Adhere to a cord an electric socket and a hose of a washer and involve them in a cowl.
4. Dress a hose on nozzles of a washer of a windscreen.