Auto Manual of VW Passat B5



VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
- 13. An electric equipment
   13.2. The general information
    13.3. Electric chains
   13.4. Safety locks
   13.5. Rules of care of the accumulator
   13.6. Accumulator check
   13.7. Accumulator gymnastics
   13.8. The accumulator
   13.9. Gymnastics system
   13.10. The generator
   13.11. Replacement of brushes of the generator and a pressure regulator
   13.12. System of start of the engine
   13.13. A starter
   13.14. The traction relay of a starter
   13.15. Replacement of bulbs of external illumination
   13.16. Replacement of bulbs of internal illumination
   13.17. Devices of external illumination
   13.18. The executive engine of the proof-reader of light of headlights
   13.19. Adjustment of light of headlights
   13.20. Gas-discharge lamps of headlights of a passing light
   13.21. A combination of devices
   13.22. Multipurpose switches of a steering column
   13.23. Switches
   13.24. A radio receiver
   13.25. High-frequency loudspeakers
   13.26. Low-frequency loudspeakers
   13.27. The aerial
   13.28. Check of a heater of back glass
   13.29. The engine of a screen wiper of a windscreen
   13.30. The engine of a screen wiper of back glass
   13.31. The pump стеклоомывателя
   13.32. System of the central blocking of locks
   13.33. The basic malfunctions of the generator
   13.34. The basic malfunctions of a starter
    13.35. Electric schemes



49e3918c

13.23. Switches
THE GENERAL DATA

The prevention

Before removal of any switch remove a wire of weight from the accumulator and repeatedly connect it to the accumulator only after switch installation.


THE SWITCH OF ILLUMINATION AND THE PROOF-READER OF LIGHT OF HEADLIGHTS

Arrangement of clamps of the switch of illumination


Removal of the bottom panel of furnish of the panel of devices from outside the driver

1 – a lateral cover,
2 – the bottom panel of furnish,
3 – the switch of light,
4 – the proof-reader of light of headlights

Arrows note an arrangement of screws of fastening of the bottom panel of furnish.

PERFORMANCE ORDER
1. Remove a decorative cover from the left end face of the panel of devices, fig. Removal of the bottom panel of furnish of the panel of devices from outside the driver see.
2. Unscrew screws, крепящие the bottom panel of furnish of the panel of devices from outside the driver and remove it.
3. Disconnect electric sockets from the switch of illumination (3) and the proof-reader of light of headlights (4), fig. Removal of the bottom panel of furnish of the panel of devices from outside the driver see.
4. Compress clamps on the switch of illumination (arrow) and, moving it forward, take from the bottom panel of furnish of the panel of devices from outside the driver, fig. the Arrangement of clamps of the switch of illumination see.
5. For installation insert the illumination switch into panels of devices directing to the bottom furnish from outside the driver and press it to защелкивания clamps.
6. At installation of the proof-reader of light of headlights insert it from an underside to защелкивания clamps.
7. Connect electric sockets to the switch of illumination and the proof-reader of light of headlights.
8. Establish and fix the bottom furnish of the panel of devices from outside the driver.

THE SWITCH OF MANAGEMENT OF THE HATCH


Arrangement of screws of fastening of the switch of management of the hatch

 

PERFORMANCE ORDER
1. Remove рассеиватель. For this purpose insert a knife blade or other similar subject into a crack between the case and рассеивате лем and cautiously hook рассеиватель.
2. Unscrew screws, крепящие the switch, fig. the Arrangement of screws of fastening of the switch of management of the hatch see.
3. Disconnect an electric socket and remove the switch.
4. Switch installation is made in sequence, return to removal.

SWITCHES STEKLOPODEMNIKOV ON THE DOOR OF THE DRIVER

Arrangement of screws of fastening of switches стеклоподъемников on a door of the driver


Direction of clearing of a clamp and detachment of an electric socket


Switches стеклоподъемников on a door of the driver are executed in the form of the block and in the presence of malfunction it is necessary to replace all block.

PERFORMANCE ORDER
1. Remove the internal handle of a door.
2. Unscrew three screws and take switches стеклоподъемников from a door upholstery, the Arrangement of screws of fastening of switches стеклоподъемников fig. see a door of the driver.
3. Release a clamp and disconnect an electric socket from the switch block, fig. the Direction of clearing of a clamp and a detachment of an electric socket see.
4. Installation is made in sequence, return to removal.

SWITCHES STEKLOPODEMNIKOV OF BACK DOORS

Switch extraction стеклоподъемника a back door

And – the switch стеклоподъемника
In – the case

PERFORMANCE ORDER
1. Remove an internal upholstery of a back door.
2. Disconnect an electric socket from the switch стеклоподъемника. Press a lateral surface of the switch () and take it from a nest in the case of the internal handle of opening of a door, fig. switch Extraction стеклоподъемника a back door see.
3. Insert to защелкивания a rekey тель стеклоподъемника into a nest of the case of the internal handle of opening of a door.
4. The further installation is made in sequence, return to removal.

SWITCH STEKLOPODEMNIKA ON THE FORWARD DOOR OF THE PASSENGER

Direction отжатия clamps for switch removal стеклоподъемника () a forward door of the passenger

 

PERFORMANCE ORDER
1. Remove an internal upholstery of a door.
2. Disconnect an electric socket from the switch стеклоподъемника.
3. Wring out outside lateral fastenings of the switch () and take it from the case, fig. the Direction отжатия clamps for switch removal стеклоподъемника () a forward door of the passenger see.
4. Insert the switch стеклоподъемника into the case and fix it.
5. The further installation is made in sequence, return to removal.

DECORATIVE ЗАГЛУШКИ PANELS OF DEVICES
The prevention

Clamps of fastening decorative заглушки are located from two longitudinal parties заглушки.


PERFORMANCE ORDER
1. Not to scratch the panel of devices at removal decorative заглушки, stick with a sticky tape area around заглушки.
2. Using an edge of a thin screw-driver or a knife, hook decorative заглушку and take it from the panel of devices.

SWITCHES OF THE EMERGENCY LIGHT ALARM SYSTEM, HEATER OF BACK GLASS AND OTHERS

Removal of a key of the switch of the emergency light alarm system


 

Fastening of switches is carried out in the identical way.

Not to scratch the panel of devices at switch removal, stick with a sticky tape area round the switch.

PERFORMANCE ORDER
1. Using an edge of a thin screw-driver or a knife, inserted under the short party of a key of the switch, take a switch key, fig. Removal of a key of the switch of the emergency light alarm system see.
2. Flat-nose pliers take the switch from the panel of devices.
3. Disconnect from the switch an electric socket.
4. At switch installation connect to it an electric socket and fix its clamp.
5. Move the switch into a nest of the panel of devices before its fixing.
6. Establish a key of the switch to защелкивания a clamp.

THE SWITCH OF BLOCKING OF COVER ТОПЛИВОЗАЛИВНОЙ OF THE MOUTH

PERFORMANCE ORDER
1. Insert an edge of a thin screw-driver or a knife into the case of the switch and wring out and take the switch from the central console.
2. Disconnect from the switch an electric socket.
3. At switch installation connect to it an electric socket and fix a clamp.
4. Insert the switch into a nest of the central console to защелкивания a clamp.