VW Passat
The maintenance instruction
1. Maintenance service
2. Engines
3. Cooling system
4. Fuel system
5. Engine management
6. An exhaust system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. A body
12. Heating, ventilation
- 13. An electric equipment
13.2. The general information
13.3. Electric chains
13.4. Safety locks
13.5. Rules of care of the accumulator
13.6. Accumulator check
13.7. Accumulator gymnastics
13.8. The accumulator
13.9. Gymnastics system
13.10. The generator
13.11. Replacement of brushes of the generator and a pressure regulator
13.12. System of start of the engine
13.13. A starter
13.14. The traction relay of a starter
13.15. Replacement of bulbs of external illumination
13.16. Replacement of bulbs of internal illumination
13.17. Devices of external illumination
13.18. The executive engine of the proof-reader of light of headlights
13.19. Adjustment of light of headlights
13.20. Gas-discharge lamps of headlights of a passing light
13.21. A combination of devices
13.22. Multipurpose switches of a steering column
13.23. Switches
13.24. A radio receiver
13.25. High-frequency loudspeakers
13.26. Low-frequency loudspeakers
13.27. The aerial
13.28. Check of a heater of back glass
13.29. The engine of a screen wiper of a windscreen
13.30. The engine of a screen wiper of back glass
13.31. The pump стеклоомывателя
13.32. System of the central blocking of locks
13.33. The basic malfunctions of the generator
13.34. The basic malfunctions of a starter
13.35. Electric schemes
|
Decoding of the symbols put on a label of the accumulator
1 – At accumulator service it is necessary to observe rules under the safety precautions, stated in the operation manual.
2 – In the accumulator there is a corroding acid and it is necessary to be careful, that acid has not spilt from the accumulator.
3 – do not use open fire about the accumulator.
4 – At work with the accumulator use goggles. |
5 – Hold the accumulator in a place not accessible to children.
6 – At recycling the accumulator hand over only in the points intended for it.
7 – do not throw out the accumulator together with household dust.
8 – Gaza, allocated at accumulator gymnastics are explosive. |
Connection of a hose for a conclusion of gases from the accumulator, formed at its work
Elements of fastening of the accumulator
|
1 – a basic arm,
2 – a fixing plate,
3 – a bolt,
4 – an arm |
The accumulator is established in a back part of a motor compartment at the windscreen basis.
The prevention At a detachment of plugs of the accumulator in blocks of memory of control means the data about the written down malfunctions is erased, therefore before a detachment of plugs of the accumulator it is desirable to address in a specialised workshop for a call from memory of the malfunctions written down in it. After connection of the plug of the accumulator it is necessary to make active and reprogram стеклоподъемники with an electric drive, and also position of rear-view mirrors and seats.
Also if in the car the radio receiver with a code before a detachment of plugs from the accumulator, check up is established that you have a code for repeated activization of the receiver. Otherwise to place a radio receiver in operation it will be possible only at specialised station a Volkswagen.
At installation of the new accumulator it is necessary to use only the accumulator with a conclusion of the gases formed at work of the accumulator, fig. Connection of a hose for a conclusion of gases from the accumulator, formed see at its work.
Removal
PERFORMANCE ORDER |
1. Switch off ignition. |
2. Open a cowl. |
|
3. Remove the negative plug from the accumulator and move it aside. |
4. Remove a protective cover, ослабьте fastening and remove the positive plug from the accumulator. |
|
5. In the bottom part of the accumulator unscrew a bolt and remove a plate of fastening of the accumulator. |
6. Move the accumulator aside, fastening of the second party of the accumulator will thus be released, and take the accumulator from a motor compartment. |
7. On the accumulator there is a label with warning symbols, fig. Decoding of the symbols put on a label of the accumulator see. |
|
Installation
The prevention At installation аккумулято ра do not press a hose, it is intended ный for tap of the gases allocated at work of the accumulator. In the pipeline of tap of gases there is a valve which protects the accumulator from return flash.
PERFORMANCE ORDER |
1. Establish one party of the accumulator on a basic arm, fig. Elements of fastening of the accumulator see. |
2. From the second party fix the accumulator and screw its bolt, having tightened its moment of 20 Nanometers. |
3. Check up reliability of fastening of the accumulator, otherwise accumulator service life it can be considerable it is reduced. |
4. Connect to the accumulator at first the positive plug, and then negative and fix them, having tightened nuts of fastening by the moment of 5 Nanometers. |
5. If in the car the radio receiver with a code is established, repeatedly reprogram it. |
6. Establish time for hours. |
7. Make active стеклоподъемники with an electric drive. |
7а. Close outside the car through a door of the driver or a door of the forward passenger. Check up, that glasses and doors have been reliably closed. |
7б. Repeatedly close the car a key, thus keep a key in the closed position at least one second.
The prevention If there is a defect electric стеклоподъемником illumination of buttons of management on a door will blink.
|
8. Make active function of storing of positions of external rear-view mirrors and seats. |
8а. Open a door of the driver. |
8б. Include ignition. |
8в. Management buttons move sitting of the driver forward and upwards against the stop. |
8г. Management buttons incline a back of sitting of the driver against the stop forward. |
8д. Switch off ignition. |
|
|
|