Auto Manual of VW Passat B5 |
|
VW Passat The maintenance instruction 1. Maintenance service 2. Engines 3. Cooling system 4. Fuel system 5. Engine management 6. An exhaust system 7. Transmission 8. A running gear 9. A steering 10. Brake system 11. A body 12. Heating, ventilation - 13. An electric equipment 13.2. The general information 13.3. Electric chains 13.4. Safety locks 13.5. Rules of care of the accumulator 13.6. Accumulator check 13.7. Accumulator gymnastics 13.8. The accumulator 13.9. Gymnastics system 13.10. The generator 13.11. Replacement of brushes of the generator and a pressure regulator 13.12. System of start of the engine 13.13. A starter 13.14. The traction relay of a starter 13.15. Replacement of bulbs of external illumination 13.16. Replacement of bulbs of internal illumination 13.17. Devices of external illumination 13.18. The executive engine of the proof-reader of light of headlights 13.19. Adjustment of light of headlights 13.20. Gas-discharge lamps of headlights of a passing light 13.21. A combination of devices 13.22. Multipurpose switches of a steering column 13.23. Switches 13.24. A radio receiver 13.25. High-frequency loudspeakers 13.26. Low-frequency loudspeakers 13.27. The aerial 13.28. Check of a heater of back glass 13.29. The engine of a screen wiper of a windscreen 13.30. The engine of a screen wiper of back glass 13.31. The pump стеклоомывателя 13.32. System of the central blocking of locks 13.33. The basic malfunctions of the generator 13.34. The basic malfunctions of a starter 13.35. Electric schemes 
|
13.4. Safety locks
Arrangement of the block of safety locks on the left side of the panel of devices Visual check of integrity of a safety lock Use of tweezers for safety lock removal Arrangement of safety locks on the block of safety locks Fuses are placed in the block of safety locks located on the left side of the panel of devices, fig. the Arrangement of the block of safety locks on the left side of the panel of devices see. The arrangement of safety locks and the electric chains protected by safety locks, are resulted on a label located from the inside on a cover of the block of safety locks. Always replace a safety lock with other safety lock of the same capacity. Each safety lock has an inscription about size of a protected current. Never replace a safety lock more than once, without having defined its reason перегорания. Additional safety locks are available on the relay block, the additional block of the relay and electronics block. The relay block is located in car salon on the left side under the panel of devices. Electronics block is located on the left side about a partition of a motor compartment. On models with diesel engines the safety lock of system of preliminary heating of the diesel engine is located on a relay arm in electronics block. For replacement of safety locks open a cover for what insert a screw-driver into a groove from the bottom party which is noted by an arrow and press a cover. If the safety lock has fused, means, the conductor connecting contacts of a safety lock, is broken off, fig. Visual check of integrity of a safety lock see. To remove a safety lock, take advantage of tweezers for extraction of a safety lock from a socket (fig. Use of tweezers for safety lock removal see). Get a safety lock from tweezers. The wire in a safety lock is swept easily up and will be broken off, if the safety lock has fused. Establish the new safety lock calculated on the same current. From an underside each safety lock has an inscription about size of a protected current. Besides, colour of a safety lock also corresponds to size of a protected current.
The prevention
Protection automatic machines Electric drives all together стеклоподъемников and the hatch are protected also by the automatic machine of protection which in case of an overload is automatically switched off (for example, at примерзании glasses) and in some seconds again joins. |
|